/interface/ethernet/monitor

官方原文约 6 分钟阅读

monitor

/interface/ethernet/monitor 的 RouterOS 命令参考。

interface/ethernet/monitor

Type: Command

只读参数	类型	描述
`name`	string
`status`	enum (unknown \| link-ok \| no-link \| initializing \| auto-init-failed)
`auto-negotiation`	enum (incomplete \| done \| no-negotiation \| failed \| restarted \| disabled \| not-supported) { incomplete:0, done:1, no-negotiation:2, failed:3, restarted:4, disabled:5, not-supported:6 }
`rate`	enum (unknown \| 10Mbps \| 100Mbps \| 1Gbps \| 2.5Gbps \| 5Gbps \| 10Gbps \| 25Gbps \| 40Gbps \| 50Gbps \| 100Gbps \| 200Gbps \| 400Gbps) { unknown:0, 10Mbps:1, 100Mbps:2, 1Gbps:3, 2.5Gbps:4, 5Gbps:5, 10Gbps:6, 25Gbps:7, 40Gbps:8, 50Gbps:9, 100Gbps:10, 200Gbps:11, 400Gbps:12 }
`full-duplex`	bool
`tx-flow-control`	bool
`rx-flow-control`	bool
`fec`	enum (off \| fec74 \| fec91) { off:0, fec74:2, fec91:3 }
`supported`	multi { array-id }
`sfp-supported`	multi { array-id }
`advertising`	multi { array-id }
`link-partner-advertising`	multi { array-id }
`default-cable-setting`	enum (short \| standard) { short:0, standard:1 }
`combo-state`	enum (copper \| sfp) { copper:1, sfp:2 }
`sfp-module-present`	bool
`sfp-rx-loss`	bool
`sfp-tx-fault`	bool
`sfp-type`	enum (unknown \| SFP/SFP+/SFP28/SFP56 \| DWDM-SFP/SFP+ \| QSFP \| QSFP+ \| QSFP28/QSFP56 \| QSFPDD \| QSFP-CMIS)
`sfp-cmis-revision`	composite { major: num , minor: num }
`sfp-cmis-module-state`	enum (low-power \| power-up \| ready \| power-down \| fault)
`sfp-connector-type`	enum (unknown \| SC \| LC \| optical-pigtail \| multifiber-parallel-optic-1x12 \| multifiber-parallel-optic-1x16 \| copper-pigtail \| no-separable-connector \| RJ45)
`sfp-encoding`	enum (unspecified \| 8B/10B \| 4B/5B \| nrz \| manchester \| sonet \| 64B/66B \| 256B/257B \| pam4)
`sfp-link-length-sm`	num
`sfp-link-length-om1`	num
`sfp-link-length-om2`	num
`sfp-link-length-om3`	num
`sfp-link-length-om4`	num
`sfp-link-length-om5`	num
`sfp-link-length-cable-assembly`	num
`sfp-link-length-copper-active-om4`	num
`sfp-vendor-name`	string
`sfp-vendor-part-number`	string
`sfp-vendor-revision`	string
`sfp-vendor-serial`	string
`sfp-manufacturing-date`	string
`sfp-power-class`	num
`sfp-max-power`	num
`sfp-wavelength`	num
`sfp-dwdm-channel-spacing`	num
`sfp-temperature`	num
`sfp-supply-voltage`	num
`sfp-tx-bias-current`	num
`sfp-tx-power`	num
`sfp-rx-power`	num
`sfp-mac`	macAddr
`phy-regs`	multi { array-id, method: string }
`eeprom-checksum`	enum (bad \| good)
`eeprom`	string