/interface/bridge/monitor
当前显示英文原文，切换到「中文」可查看译文。
monitor
RouterOS command reference for /interface/bridge/monitor.
interface/bridge/monitor
Type: Command
| Read-only Argument | Type | Description |
|---|---|---|
state | enum (disabled | disabled | enabled | enabled) | |
current-mac-address | macAddr | |
bridge-id | composite { prio: num , mac: macAddr } | |
root-bridge | bool | |
root-bridge-id | composite { prio: num , mac: macAddr } | |
regional-root-bridge-id | composite { prio: num , mac: macAddr } | |
root-path-cost | num | |
root-port | iface_enum { none:0 } | |
port-count | num | |
designated-port-count | num | |
mst-config-digest | string | |
fast-forward | bool | |
multicast-router | bool | |
igmp-querier | composite { interface: iface_enum { none:0 } , ip-address: ipAddr } | |
mld-querier | composite { interface: iface_enum { none:0 } , ipv6-address: ip6Addr } | |
declared-vlan-ids | multi { vlan-range: range } | |
registered-vlan-ids | multi { vlan-range: range } | |
mlag-state | string | Shows the MLAG connection state: connected when ICCP is established, connecting while the peers establish or re-establish the connection, or an error such as peer port not running when the configured peer port is unavailable. |
mlag-active-role | enum (primary | secondary) | The peer with the lowest priority acts as the primary device. If the priorities are the same, the peer with the lowest bridge MAC address becomes the primary. The system-id of the primary device is used for sending the (R/M)STP BPDU bridge identifier and LACP system ID. The role is shown after a successful MLAG connection. |